Hudson-robotics SoftLinx 5.0 Manuel d'utilisateur télécharger pdf (Page 44)

To detect a plate at a specific location, we use the statement Plates.PlateExists("X"), where X is the name

of the nest where the plate is located. By typing the condition below, it will only prepare a new plate if a

source plate is ready to go on the Rapid Pick source nest.

The full "Replace Target Plate" conditional statement, expanded, should look like this:

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50

Pas de commentaire

Hudson-robotics SoftLinx 5.0 Manuel d'utilisateur Page 44