Hudson-robotics SoftLinx 5.0 Manuel d'utilisateur télécharger pdf (Page 49)

Like the previous steps beforehand, check for a source plate using the following:

Check for a target plate in the sealer using the following:

3. Test the protocol.

Finally, once this part is done, test the protocol using empty plates and no liquid. Ensure that all of your

source plates and destination plates are defined, and all initial plate locations match those used by this

protocol. By testing the protocol, you will ensure that the protocol is written properly and no media is

wasted on a faulty run.

1 2 ... 44 45 46 47 48 49 50

Pas de commentaire

Hudson-robotics SoftLinx 5.0 Manuel d'utilisateur Page 49