Hudson-robotics RapidWash Manuel d'utilisateur télécharger pdf (Page 23)

Section 3 - Maintenance of the RapidWash Manifold

3.1 - Removal and Installation of the Manifold

The RapidWash is shipped without the manifold assembly attached to the unit.

The manifold assembly is shipped with a shipping bracket to protect the tips. This

shipping bracket must be removed before the Manifold assembly can be installed onto the

RapidWash. The Manifold assembly has a quick disconnect fitting that holds the

Manifold (Figure 27).

Figure 27

The side of the manifold has two locating holes that allow the manifold to slide onto the

two locating pins on the manifold mount (Figure 28).

Manifold Quick

Disconnect Fitting

1 2 ... 18 19 20 21 22 23 24 25 26 27

Pas de commentaire

Hudson-robotics RapidWash Manuel d'utilisateur Page 23