Hudson-robotics Micro10x Manuel d'utilisateur télécharger pdf (Page 22)

Section 3 - Maintenance of the Mirco10X Fluid Path

Note: Please turn power off and disconnect all cables from the rear of the Micro10x

before performing any maintenance on the unit.

3.1 - Removal of the Pump Head

Remove the 4 mounting screws from the face of the pump (Figure 3.1.1). Support

the pump with your hand to prevent it from falling from the mounting plate.

Figure 3.1 1

Gently pull the pump diagonally away from the mounting plate. Care must be

taken not to pull the piston more than 1” out of the cylinder; damage to the piston

seals may occur (Figure 3.1.2). Once the pump head is far enough away from the

pump module you will slowly lift up on the entire pump assembly. You will need

to remove the piston drive shaft from the pivot bearing inside the pump module

(Figure 3.1.3).

4 mounting

screws for

Pump head

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Pas de commentaire

Hudson-robotics Micro10x Manuel d'utilisateur Page 22