Hudson-robotics LabLinx Manuel d'utilisateur télécharger pdf (Page 24)

StackLink User Manual Hudson Robotics, Inc.

 Using a small flat head screwdriver, gently pry the fuse holder tray away from its

housing to access the fuses. The Fuse holder door swings down.

 Remove the blown fuse. Replace it with the spare fuse.

 Slide the fuse holder tray back into the AC inlet until it clicks. Make sure when re-

installing the holder the AC line voltage reads the correct way on the inlet

 Reconnect the power cord to the StackLink and reconnect all other cables

previously disconnected.

 Verify correct fuse replacement by turning the StackLink switch to ON position--

the light will illuminate immediately.

Figure 15

Location of fuse

holder tray

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 33 34

Pas de commentaire

Hudson-robotics LabLinx Manuel d'utilisateur Page 24